Self-propelled TMR mixers (12–36 m³)
Milling head, engine, cab and tub in one machine: when one operator replaces a tractor, a loader and a second driver — and when it does not.

How a self-propelled mixer works
The machine drives to the bunker, lowers a milling head (a rotating drum with knives) and cuts silage straight off the face onto an elevator into the tub. It does the same for haylage and commodity piles, weighs every ingredient on its own scale, mixes on the way to the barn and discharges along the bunk. One person, one engine.
Milling drum vs. silage bucket
Most current units use a milling drum: it leaves a clean, flat face that lets in less air, which is where the feed shrink savings come from. Some compact machines load with a hydraulic bucket or claw instead — cheaper to maintain, rougher on the face.
Drive and maneuverability
Two-wheel steer is enough on open pads. Tight freestall alleys and old tie-stall barns push buyers to 4WD and four-wheel steering (4WS) or multi-wheel steering, which can turn the machine almost on its own length. Road speeds of 25–40 km/h matter for farms with barns on separate sites.
Capacity classes
| Class | Tub | Engine | Typical herd per batch |
|---|---|---|---|
| Compact | 12–16 m³ (425–565 cu. ft.) | 140–175 HP | 150–300 cows |
| Mid-size | 16–24 m³ (565–850 cu. ft.) | 180–230 HP | 300–600 cows |
| Heavy | 24–36 m³ (850–1,270 cu. ft.) | 220–300 HP | 600+ cows per load |
The economics in one paragraph
A self-propelled replaces a feeding tractor, a loader or telehandler and usually 1.5–3 hours of labor a day. Against that sits $100,000–$250,000 more capital than a pull-type, and a few thousand dollars a year more upkeep on the engine, hydrostatic drive and milling head. Most farms find the tipping point at 500 to 1,000+ cows, earlier if labor is the constraint or barns are connected by road. Run your own numbers in the ROI calculator.
Redundancy and service risk
With a pull-type, a broken tractor means hitching another one. A self-propelled is a single point of failure: engine, hydrostatic pump or milling-head bearing down means no feed until it is fixed. Before buying, ask how far the nearest service truck is, which wear parts the dealer stocks, and whether you keep an old pull-type as backup.
Price tiers
| Condition | Price range | What to expect |
|---|---|---|
| Older / high-hour | $30,000–$90,000 | 8,000+ engine hours, milling head and elevator chain likely due |
| Late-model used (2020–2024) | $100,000–$180,000+ | Often ex-dealer demo or trade-in, warranty sometimes transferable |
| New (2025–2026) | $200,000–$350,000+ | Depends on tub size, 4WD/4WS, engine tier and scale package |
Builders in this class
Self-propelled TMR mixers sold into North America and other dairy regions include RMH (Liberty, VSL, Vulcan, Premium, TurboMix, Triple 36), Siloking, Trioliet (Triotrac), Kuhn (SPV) and Strautmann, alongside a few North American builders. See the RMH specifications and the brand comparison for capacities and dealer coverage.
Looking for a used self-propelled or a quote on a specific size? Send the spec and we route it to dealers that carry it.