Independent TMR mixer sizing & multi-brand sourcing · US & Canadaquotes@rmhmixers.comparts@rmhmixers.com
Feeding guide

TMR mix quality, Penn State Particle Separator & feed shrink

Target particle sizes for a lactating ration, how to spot sorting at the bunk, loading order and mix time, and what 5–15% feed shrink costs.

Cows eating a fresh total mixed ration along the feed bunk
Shake the fresh TMR and the refusals the same day to see sorting.

PSPS targets for a high-producing lactating TMR

The Penn State Particle Separator is a stack of sieves you shake by hand to see how the ration splits by particle length. Targets, as percent of as-fed weight:

Top sieve (> 19 mm)
2–5%
Second sieve (> 8 mm)
> 50%
Third sieve (> 4 mm)
10–20%
Bottom pan (< 4 mm)
25–30%

Bars show the target band on a 0–100% scale.

Diagnosing sorting

Shake a sample of fresh TMR at feed-out and a sample of refusals before push-up or clean-out. If any sieve shifts by more than 5 percentage points between the two, cows are sorting — typically picking out the fines and leaving long material. Sorting means some cows eat a hotter ration than formulated, which raises the risk of subacute ruminal acidosis (SARA).

Mixer causes of a bad shake

What you seeLikely mixer causeFix
Too much on the top sieveDull or missing knives, short mix time, hay added too lateSharpen or replace knives; process hay first
Too much in the panOver-mixing, knives too aggressive, worn kick platesShorten mix time; check kick-plate position
Batch-to-batch variationOverfilled tub, worn flighting, inaccurate scaleLoad to 60–80% of struck capacity; check flighting and load cells

Loading order and mix time

  1. Long dry hay or straw first, processed until it reaches target length.
  2. Grains, protein and commodities.
  3. Minerals and small inclusions — into the middle of the load, never against the tub wall.
  4. Haylage, then corn silage.
  5. Liquids and wet by-products last.
  6. Mix 3–5 minutes after the last ingredient, then deliver. Longer is not better.

The cost of feed shrink

Shrink — feed lost to spoilage at the face, wind, tracking, and loader spillage — commonly runs 5–15% between the pile and the bunk. On a 500-cow dairy feeding $8 per cow per day, the annual feed bill is about $1.46 million; saving just 1% shrink is worth $14,600 a year. A clean, tight face (from a milling head or a careful loader operator), covered piles and accurate weighing are where it comes back. Run the ROI calculator with your own shrink figure.